For various reasons, the limits of the servo motors may need to be reset. This should be done whenever any moving part is taken off or replaced.
To reset the Servo Limits, do the following steps:
1. Press the 'Setup' button
2. Press the 'Servo' button
3. Press the 'Reset Limit' button
4. Press the 'Find Limit' button
5. The edger may prompt you to close the chuck and door to continue.
After resetting the servo limits, you can return to normal operation. If this did not solve the issue, please submit a support ticket.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article