Daily
Scan Lens Tabs (Approved tech by GM)
Clean all equipment surfaces (polish, dust, Etc)
Clean any lap tools used (Clean Surface well, make sure #s are legible)
Clean any Alloy Blocks used (wipe/scrub polish)
Weekly
Clean 7E Filter
Clean 2G Filter
Clean out Alloy Reclaim Tank of sediment
Monthly
505 Pin replacement
Clean Lap Tool Shelving (Polish/Dust)
Quarterly
Layout Marker Calibration
3B Axis Calibration
7E Axis Calibration
7E polish Wheel Cleaning
2G Axis Calibration
Semi Annual
505 Wobble Plates
505 Pattern Calibration
Clean inside 3B (dust removal)
Clean inside 4T (dust removal)
Clean inside Cure Unit (dust removal)
Replace 2G Bit
Annual
Deep Clean 7E (Carriage Disassembly)
Deep Clean 2G (Carriage Disassembly)
As Needed
Size/Bevel Calibration on 7E
Center Thickness Calibration on 2G
Axis Calibrations on 7E, 2G, & 3B
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article