Things to check:
- Finer Air Regulator set to 18 PSI, time at 90 Seconds
- Polisher Air Regulator set to 24 PSI, time at 240 Seconds
- Polish Quality: Check Consistency, discoloration, Etc. Replace polish.
- Change Polish Pad Roll to eliminate the possibility of a bad sample
(Make sure the batch # is different)
- Perform Lens Curve Calibration on 2G(s). Poly Lenses should fine out within 20 seconds on high.
- Verify Pattern Calibration on Cylinder Machines
- Verify Pin Pressure on Cylinder Machines
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article